Table of Contents

Xylophone Congiguration

(Stefan, Benno, Bryan, Andrew, Sean, Marina)

Motivation

Why xylophone

Question: Do we still need the xylophone?

Possible Tasks:

LIGO Voyager GWINC model

GWINC files for Voyager,CE, … at https://dcc.ligo.org/LIGO-T1500293

The GWINC model can be found on git.ligo (link). Download from the whole repositry and run the BlueBird5.m file to recreate the Voyager Blue design sensitivity plot from the LIGO Voyager Design Concept document (DCC link) change parameters in IFOModel_123_2000.m or IFOModel_120_1550.m

Infrastucture

The interferometer model file was modified to reflect the infrastucture of ET.

Parameters changed:

Seismic and Newtownian Noise

The site seismic paramters were modified to approximate the potential ET sites. Numbers were based off the Black Forest study.

Squeezing

Within the GWINC model we included frequency dependent squeezing. To compensate for the change in cavity length and optical power the filter cavity parameters had to be tuned. This was intially done for 10dB of squeezing.

Paramters changed:

The filter cavities bandwidth was reduced by decreasing the input transmission by a factor of 4 and the cavity was detuned by +10deg, this roughy optimised the broadband quantum noise reduction.

Suspension Thermal Noise

Task: Use model of the suspension thermal nosie for ET design at 120K with 211kg test masses, developed by suspension working group. Include this in the GWINC model.

Sensitivity Implications

What do we lose by abandoning the xylophone

PRELIMINARY RESULTS:

Suspension TN 120K 200kg 1.5m

Suspension thermal noise curves. For ET at 120K with 1.5m long final suspension stages and 211kg test mass.

Conervative estimate: 3mm diameter fibres, 69MPa:

et120k15m69mpa3mmdia.mat

More ambitious estimate: 1.5mm diameter fibres, 275MPa:

et120k15m275mpa15mmdia.mat

Summary/Conclusions

Our aim over the course of the workshop was to produce a preliminary (*very* rough) plot pulling together the general LIGO Voyager design and the improved seismic/NN/suspension aspects of ET. Ultimately this should provide a framework/baseline from which to hang our principal question - what do we lose if we abandon the xylophone approach?

et_voyager_1550.fig

This is a first attempt at pulling several strands of a complex model together. We may have missed some elements in getting the assorted files spread across multiple directories (and written by several different people) together. We have not optimised the quantum noise performance. We have not touched the coating noise from the Voyager design. We have only considered the 120K 1550nm 200kg system so far.

If we believe the plot, there are some obvious points to note - firstly, we lose some sensitivity at the high end compared to ET-HF (factor ~2) and some at the low end (factor ~6) but with some small improvement in the bucket.

Secondly, we are limited by quantum noise across the whole band of interest… this suggests there’s quite a lot of scope to improve/optimise squeezing and filter cavity parameters etc.

We cannot stress enough - preliminary result only. Do not trust this!

Next Steps

Verify we’ve gotten everything into the model that should be there and that there aren’t any rookie errors. (in-group task, though anyone is welcome to help)

Optimise quantum noise. (either tweak in-group or splice in the work from the quantum noise group)

Once happy check the other design options - 20K, 2000nm, etc. (in-group or anyone who’s interested)

Ultimately we’ll want a central IFO model that we all agree on and which can be used to calculate all the assorted noise contributions. (everyone)